Table of Contents
Advertisement
QUICKSTART GUIDE
QS–24
A valid IP address and subnet mask can now be programmed into the Switch using the IP
config command as follows:
Type in "ipconfig ip=".
Enter the IP address (in our example we will use a unique address
between 3.94.247.1 and 3.94.247.254), followed by a space.
Type in "mask=" and enter the mask (in our example system we
would use 255.255.252.0).
If a default gateway is also required enter a space and type "dgw="
Enter the IP address of the gateway, then select the enter key.
The switch will then indicate that the parameters have been set.
Save the settings using the Save command.
UR SWITCH MODULE – QUICKSTART GUIDE
Advertisement
Table of Contents
