Table of Contents
Advertisement
Installation
System Diagram
UTP Power Supply Link Setup
1. SUB-2000 → 4CH Power Supply → 4Ch Receiver → DVR/Monitor/Controller
The maximum power transmission distance for the camera is 300m(1000ft), and the
distance between the camera and the 4ch Receiver cannot exceed 900m(3000ft).
SPU-400T
300m(1000ft) or Less
SUB-2000
900m(3000ft) or Less
2. UTP Receiver Link Setup(Additional Power input is needed)
SUB-2000 → 1Ch Passive Receiver → DVR → Monitor
225m(750ft) or Less
1Ch Passive Receiver
14
COLOR CCD CAMERA
RS-485
VIDEO
SPU-400R
SCC-3100A
UTP CABLE
BNC CABLE
RS-485
User Guide
Notes
• U sing the product with third-party UTP peripherals may result in degradation of product
function and performance.
• A ttenuation and distortion in signal may occur if the maximum transmission distance is
exceeded. Please note that depending on the installation environment/condition, the
signal may become attenuated and distorted and cause the camera to function
incorrectly even when the transmission distance is within the maximum.
• I f using RS-485 communication, please use the SAMSUNG-T, SAMSUNG-E, PELCO-D,
PELCO-P, BOSCH, HONEYWELL, VICON and PANASONIC Protocol.
• I f you are using the 1Ch Passive Receiver system setup, please connect the adapter
(AC 24V or DC 12V) directly to the camera.
If the distance between the camera and the Power Supply exceeds
300m(1000ft), please connect an AC 24V or DC 12V adapter to the
Power Input Terminal Block(Accessory). Impressing power when
the maximum transmission distance is exceeded may result in
degradation of picture quality or even camera failure.
Using Coaxial Communications
• Coaxial Communications System
• OSD Control method
CAMERA
DVR
CONTROLLER
SET
MENU/ENTER
OSD KEY
UP
UP KEY
JOYSTICK UP
DOWN
DOWN KEY
JOYSTICK DOWN
LEFT
LEFT KEY
JOYSTICK LEFT
RIGHT
RIGHT KEY
JOYSTICK RIGHT
DVD
15
COLOR CCD CAMERA
DVR
: BNC
•
• ---- : RS-485
User Guide
Advertisement
Table of Contents
