Special Oil; Adjustble Taper Lever 5 Detent Taper Control - Conair HC318DWXCSC Instructions Manual

SPECIAL OIL

To maintain the blades of your Conair
clipper in peak condition, oil them after
every three or four haircuts. Gently place a
few drops of oil on the teeth of the blades,
using the special Conair oil included with
your set. Turn the clipper on for a
minute,then turn off. This light, natural oil
was formulated specifically for the Conair
high-speed clipper. Because it is the right
oil to use, it will not slow down the blades.
Never use any other product; there is no
substitute for Conair oil.
ADJUSTBLE TAPER LEVER
5 DETENT TAPER CONTROL
Just like levers on professional clippers, the
Conair taper lever is positioned at your
thumb so you can hold the clipper in your
hand and adjust the lever at the same
time...while you're clipping. This taper lever
eliminates the need in some situations for an
attachment comb because it lets you gradu-
ally adjust the close-
ness of the cut. For
the closest cut and
the shortest hair,
push taper lever up
as far as it will go to
level #1. To increase
cutting length, slowly push lever down. If
you push to the lowest position level #5, it
®
will leave hair about the same length as the
short attachment comb.
Because a different cutting edge is used in
each setting, the taper lever lengthens the
life of your blades. Packed-in hair can slow
down any clipper. To remove it, without
removing the blades. Take your cleaning
®
brush and brush the hair from the blades. If
you do this after every clipping, especially
with heavy hair cutting, the blades should
remain free of cut hair. If clipper stops cut-
ting and this action doesn't help, you might
have to loosen the blades to remove the hair.
NOTE: Never pull on the clipper cord.
Never twist or wrap the cord around the
clipper; lay it flat with the cord coiled up
when not in use.
Close Cut
Longer
Cut