For Direct Plug-In Operation; Battery Removal Instructions; To Cutting Hair At Home; Medium To Long Cut - Conair HC318DWXCSC Instructions Manual

FOR DIRECT PLUG-IN OPERATION

1. Connect the charging jack into the recep-
tacle at the end of the clipper.
2. Plug the adapter unit into the electric out-
let.
3. Turn the switch to "Off" position, let the
clipper charged for few minutes first.
4. Turn the switch to "On" position.
5. Unplug the adapter unit after use.
6. After use, store in a dry place away from
small children.
7. Do not wrap cord around the clipper.
CONTAINS NICKEL-
CADMIUM BATTERY.
MUST BE COLLECTED,
RECYCLED OR DIS-
POSED OF PROPERLY.
DO NOT DISPOSE OF
IN MUNICIPAL WASTE.

BATTERY REMOVAL INSTRUCTIONS

1. Using a small Phillips screwdriver,
remove the screw on the bottom housing at
back of the clipper.
2. Remove the top housing by hand.
3. Now the battery is exposed so you can
separate the wire connectors. Carefully hold
the wires on each side of the connector and
gently cut the wires. The connector will sep-
arate and the batteries can be removed from
the inner housing. Bring the battery to the
nearest collection center for disposal or call
the toll-free RBRC information line at 1-800-
8-BATTERY. RBRC is a trademark of The
Rechargeable
Corporation. DO NOT throw the batteries
into the normal municipal waste system.
Battery Recycling
Never use cord to pull clipper.Never twist or
otherwise obstruct cord. To store, coil cord
loosely and secure with a twist tie.
Also included are 10 attachment combs for
different hair lengths, barber scissors, a
barber comb with straight teeth, a full
length barber cape, a neck brush, a hard
case for easy storage, and a styling comb.
It also comes with lubricating oil, a cleaning
brush, adaptator and a blade guard for easy
maintenance of the clipper blades.
THE CONAIR GUIDE

TO CUTTING HAIR AT HOME

Before you start:
1. Inspect your clipper to make sure it is
free of hair and dirt, is properly oiled and is
running smoothly.
2. Place a towel or cape around the neck of
the person getting the haircut.
3. Seat the person so that his/her head is at
your eye level. This gives you greater visi-
bility and control.
4. Comb hair until it is tangle-free. Hold the
clipper in a comfortable grip. Now you're
ready to cut.

MEDIUM TO LONG CUT

To begin, cut only a small amount of hair
until you become used to the length each
attachment leaves the hair. Try the longest
attachment on the clipper first. If you want a
shorter cut, you can then use shorter combs.
• Short attachment comb (number 1) cuts
hair to 1/8".