Threading The Machine - Viking Huskystar 215 User Manual

3
1
2
4
5
6
1
3
5
2
4
6

Threading the Machine

Switch off the main switch.
Raise the take-up lever to its highest
position by turning the handwheel toward
you. Raise the presser foot. Place the spool
on the spool pin as shown, with the thread
coming from the back of the spool.
1 Draw the thread into the thread guide
using both hands.
2 While holding the thread near the spool,
draw it down into the tension area and
then around the check spring holder.
3 Firmly draw the thread up and through
the take-up lever from right to left.
4 Then, draw the thread down and slip it
into the lower thread guide.
5 Draw the thread down and slip it into
the needle bar thread guide.
6 Thread the needle eye from front to
back.
NOTE: You may want to cut the end of the thread
with sharp scissors for easier needle threading.
11