Site Preparation - Electrolux EI24WC65GS Use & Care Manual

Wine cooler / beverage center
Hide thumbs

Advertisement

Table of Contents
6
Installation

Site Preparation

1 Position the unit on a flat, level surface
capable of supporting the entire weight of the
unit. Remember the unit will be significantly
heavier once it is fully loaded.
2 This unit requires a grounded and polarized
115 VAC, 60Hz, 15A circuit (normal
household current).
3 Avoid connecting the unit to a Ground
Fault Interruptor (GFI). GFIs are prone to
nuisance tripping which will cause the unit to
shut down. GFIs are generally not used on
circuits which power equipment that must run
unattended for long periods of time.
4 The unit must be installed according to your
state and local laws and regulations.
WARNING
ELECTROCUTION HAZARD!
Electrical Grounding Required. This appliance
is equipped with a three prong (grounding)
polarized plug for your protection against
possible shock hazards.
• NEVER remove the round grounding prong
from the plug.
• NEVER use a two-prong grounding adapter.
• NEVER use an extension cord to connect
power to the unit.
Where a two-prong wall receptacle is
encountered or a longer power cord is
required, contact a qualified electrician to
have it replaced in accordance with applicable
electrical codes.
5 Position the unit to allow free air flow through
the front grille.
6 Wipe out inside of unit with a damp cloth.
7 Be sure to install the Anti-Tip bracket. Follow
the instructions provided with the Anti-Tip
bracket kit.
WARNING
The Anti-Tip Kit must be installed on this unit
before it is used. Double stacking units may
cause serious personal injury.

Advertisement

Table of Contents
loading

  Related Manuals for Electrolux EI24WC65GS

Table of Contents