Included Accessories - Husqvarna Viking Sapphire 870 QUILT User Manual

Included accessories

Presser Feet
Utility Foot A
Utility Foot B
Buttonhole Foot C
Blind Hem Foot D
Zipper Foot E
Non-Stick Glide Foot
H
Edging Foot J
Quilter's 1/4" Piecing
Foot P
(Only with 870 Quilt)*
Clear Open Toe Foot
(Only with 870 Quilt)*
Embroidery/Darning
Foot R
One-Step Sensor
Buttonhole Foot
3
2 4 5
1
*Sold separately for 850 and 830
6
Attached on the machine upon delivery. This foot is used mainly for straight stitching and
zigzag stitching with a stitch length longer than 1.0.
When sewing decorative stitches or short zigzag stitches and other utility stitches with
less than 1.0 mm stitch length, use this foot. The tunnel on the underside of the foot is
designed to feed smoothly over the stitches.
This foot is used for sewing buttonholes step by step. Use the guide lines on the toe of
the foot to position the garment edge. The two tunnels on the bottom of the foot ensures
a smooth feed over the buttonhole columns. The fi nger on the back of the foot holds
cording for corded buttonhole.
This foot is used for blind hem stitches. The inner edge of this foot guides the fabric. The
right toe of the foot is designed to ride along the hem edge.
This foot can be snapped on either to the right or to the left of the needle, making it easy
to sew close to both sides of the zipper teeth. Move needle position to right or left to sew
closer to zipper teeth or for covering large cording.
This foot, with a non-stick coating underneath, is used when sewing foam, vinyl, plastic, or
leather to minimize the risk of these materials sticking to the foot.
This foot is used for overcasting and seam/overcasting. Stitches form over the pin which
prevents puckering at the edge of the fabric.
This foot is used when piecing quilt blocks. The foot has seam guide marks 1/4" (6 mm)
and 1/8" (3 mm). The foot can only be used with straight stitch.
For satin stitch applique, taper stitches and decorative stitches. The tunnel on the underside
of the foot feeds smoothly over the stitches and the transparent foot with open front gives
greater visibility for accuracy.
For free-motion darning, quilting and embroidery.
When connected to the machine, the buttonhole is sewn in a suitable length to the button
size that has been entered into the machine.
9
7
8
6 10
1. Thread nets. Slide on the spool when using
2. Non-Stick glide plates (2)
3. Needles
4. Light bulb remover
11
5. Seam ripper
6. Brush
7. Screwdriver
8. Edge/quilting guide (Only with 870 Quilt).
9. Felt pad
10. Bobbins (5)
11. Extra spool caps, one large, one small.
12
12. Clearance plate/Button Reed
synthetic threads that easily unwind (2).