Included Accessories - Husqvarna Viking Opal 690Q User Manual

INCLUDED ACCESSORIES

Presser Feet
Attached on the machine upon delivery. This foot is used mainly for straight stitching and zigzag stitching with
a stitch length longer than 1.0.
When sewing decorative stitches or short zigzag stitches and other utility stitches with less than 1.0 mm stitch
length, use this foot. The tunnel on the underside of the foot is designed to feed smoothly over the stitches.
Buttonhole Foot C
This foot is used for sewing buttonholes step by step. Use the guide lines on the toe of the foot to position
the garment edge. The two tunnels on the bottom of the foot ensures a smooth feed over the buttonhole
This foot is used for blind hem stitches. The inner edge of this foot guides the fabric. The right toe of the
foot is designed to ride along the hem edge.
Zipper Foot E
This foot can be snapped on either to the right or to the left of the needle, making it easy to sew close to both
sides of the zipper teeth. Move needle position to right or left to sew closer to zipper teeth or for covering
large cording.
Edging Foot J
at the edge of the fabric.
Sensor One-Step Buttonhole Foot
When connected to the machine, the buttonhole is sewn in a suitable length to the button size that has been
entered into the machine.
Glide Sole
If sewing on foam, vinyl, plastic, or leather, the material might stick to the foot and prevent the sewing
machine from feeding properly. When using any of the above materials, sew on a piece of scrap fabric, to
make sure the machine feeds smoothly. If not, fasten the self-adhesive glide soles to the underside of the
presser foot.
– 5