Jumper Cables - Husqvarna PZ 72 Owner's Manual

Weak Battery
If "jumper cables" are used for emergency starting,
follow this procedure:
WARNING!
Lead-acid batteries generate
explosive gases. Keep sparks,
flame and smoking materials away
from batteries. Always wear eye
protection when around batteries.
IMPORTANT INFORMATION
The mower is equipped with a 12-volt
negative grounded system. The other
vehicle must also be a 12-volt negative
grounded system. Do not use the mower to
start other vehicles.

Jumper Cables

• Connect each end of the ReD cable to the
POSItIVe (+) terminal on each battery, taking
care not to short against chassis.
• Connect one end of the BLACK cable to the
neGAtIVe (-) terminal of the fully charged
battery.
• Connect the other end of the BLACK cable to a
good CHASSIS GROUnD on the mower with the
discharged battery, away from the fuel tank and
battery.
To remove cables, reverse order
• Remove BLACK cable first from chassis and
then from the fully charged battery.
• Remove ReD cable last from both batteries.
32
OPERATION
Jumper cable connection
8011-642