Roll Bar And Safety Belt; Before Starting - Husqvarna P-ZT 48 Operator's Manual

Roll Bar and Safety Belt

Operate the unit with the roll bar in the raised and
locked position and use the seat belt. There is no
rollover protection when the roll bar is down. If it is
necessary to lower roll bar, do not wear the seat belt.
Raise the roll bar as soon as clearance permits.
WARNING!
The seat belt must be used when the
roll bar is in upright position.

Before Starting

1. Read the sections Safety Instructions and
Controls before starting the machine.
2. Perform the daily maintenance before starting
(see maintenance schedule in the Maintenance
section).
3. Check that there is sufficient fuel in the fuel tank.
4. Adjust the seat to the desired position.
The following conditions must be fulfilled before the
engine can be started:
1. The blade switch for engaging the mower blades
must be depressed.
2. The parking brake must be on.
3. Both steering controls must be in the locked
(outer) neutral position.
oPeRatIon
Roll bar in upright position
Activate parking brake before starting
Place controls in neutral position
8065-011
8065-006
8065-096
27