Roll Bar And Safety Belt; Before Starting - Husqvarna PZ54 Operator's Manual

Roll Bar and Safety Belt

Operate the unit with the roll bar in the raised and
locked position and use the seat belt. There is no
rollover protection when the roll bar is down. If it is
necessary to lower roll bar, do not wear the seat belt.
Raise the roll bar as soon as clearance permits.
WARNING!
The seat belt must be used when the roll
bar is in upright position.

Before Starting

1. Read the sections on Safety and Controls before
starting the machine.
2. Perform the daily maintenance before starting
(see Maintenance Schedule in the Maintenance
section).
3. Check that there is sufficient fuel in the fuel tank.
4. Adjust the seat to the desired position.
5. Set the pin at desired cutting height. Height
selection pin is removed by rotating 180
sure that the pin is inserted fully through the both
sides of the height panels.
The following conditions must be fulfilled before the
engine can be started:
• The blade switch for engaging the mower blades
must be depressed.
• The parking brake must be on.
• Both steering controls must be in the locked
(outer) neutral position.
OPERATION
Roll bar in upright position
Seat adjustment
. Make
O
Set deck to selected cutting height
8065-011
8065-110
8065-016
27