Table of Contents
Advertisement
Winter Storage
The machine should be readied for storage at the
end of the mowing season, or if it will not be in use for
more than 30 days.
Fuel allowed to stand for long periods of time (30 days
or more) can leave sticky residues that can plug the
carburetor and disrupt engine function.
Fuel stabilizers are an acceptable option as regards
to the sticky residues that can occur during storage.
Add stabilizer to the fuel in the tank or in the storage
container. Always use the mixing ratios specified by
the manufacturer of the stabilizer. Run the engine for
at least 10 minutes after adding the stabilizer so that
it reaches the carburetor. Do not empty the fuel tank
and the carburetor if a stabilizer has been added.
WARNING!
Never store an engine with fuel
in the tank indoors or in poorly
ventilated spaces where fuel vapor
can come in contact with open
flames, sparks, or a pilot light such
as in a boiler, hot water tank, clothes
drier, etc. Handle the fuel with care.
It is very flammable and can cause
serious personal injury and property
damage. Drain the fuel outdoors, into
an approved container. Store the fuel
away from open flame or any source
of ignition. Never use gasoline for
cleaning. Use a degreaser and warm
water.
stoRage
To ready the machine for storage, follow these steps:
1.
Thoroughly clean the machine, especially under
the mower deck. Touch up damage to the paint
and spray a thin layer of oil on the underside of
the mower deck to avoid corrosion.
2.
Inspect the machine for worn or damaged parts
and tighten any nuts or screws that may have
become loose.
3.
Change the engine oil; dispose of properly.
4.
Empty the fuel tanks or add a fuel stabilizer. Start
the engine and allow it to run until the carburetor
is drained of fuel or the stabilizer has reached the
carburetor.
5.
Remove the spark plug and pour about a
tablespoon of engine oil into the cylinder. Turn
over the engine so that the oil is evenly distributed
and then refit the spark plug.
6.
Lubricate all grease zerks, joints, and axles.
7.
Remove the battery. Clean, charge, and store the
battery in a cool place, but protect it from direct
cold.
8.
Store the machine in a clean, dry place and cover
it for extra protection.
Service
When ordering spare parts, please specify the
purchase year, model, type, and serial number.
Always use genuine Husqvarna spare parts.
An annual check-up at an authorized service
workshop is a good way to ensure that the machine
performs its best the following season.
51
Hide quick links:
Advertisement
Table of Contents
