Anti-Scalp Rollers; Caster Wheels - Husqvarna P-ZT 48 Operator's Manual

Anti-scalp Rollers

Anti-scalp rollers keep the deck in the proper position
to help prevent scalping in most terrain conditions. Do
not adjust the rollers to support the deck.
Rollers are properly adjusted when they are just
slightly off of the ground when the deck is at the
desired cutting height in the operating position.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a
flat level surface.
The anti-scalp rollers can be set in three positions:
• Upper position 1 to 2½" (25 to 63 mm) grass.
• Middle position 2½" to 4" (63 to 102 mm) grass.
• Lower position 4" to 5" (102 to 127 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
IMPORTANT INFORMATION
To avoid deck damage, the anti-scalp rollers
must not be adjusted to support the deck.

Caster Wheels

Check every 200 hours. Check that wheels rotate
freely.
Removal and Installation
Remove nut and caster bolt. Pull the wheel out of
the fork. Install in reverse order. Tighten caster bolt.
Torque to 45 ft-lbs (61 Nm), then back nut off ½ turn.
NOTE: Tire should rotate freely but axle spacers
should not.
If wheels do not rotate freely take the unit to the dealer
for service.
44
maIntenanCe
Anti-scalp rollers
1. Caster bolt
2. Axle spacer
Caster wheel
2
8065-094
1
8065-030