Media Receiver - Pioneer PDP-433HDE Operating Instructions Manual

Part names

Media Receiver

Front view
PC INPUT terminal (ANALOG RGB)
STANDBY/ON
POWER
PC INPUT terminal (AUDIO)
POWER button
* If you're having problems operating the Media Receiver and want to return to normal screen, even when it
stays on (the indicator lights green), press CLEAR on the Media Receiver. Pressing CLEAR resets the System
as shown below.
• AV SELECTION resets to STANDARD
• TV channel resets to channel 1
• Multiscreen resets to normal
• Audio setting initialises
• SRS resets to Off.
• Image position is initialises
A
• Pressing CLEAR will not work if the System is in standby mode but the indicator lights red.
• Pressing CLEAR will not delete channel preset or password. See Page 54 for initialising factory preset settings when you
know your password. See Page 63 for initialising factory preset values when you have forgotten your password.
Rear view
INPUT 3 terminals (Y, P
Antenna input terminal
S-VIDEO
MONITOR OUTPUT
terminal (S-VIDEO)
MONITOR OUTPUT
terminal (VIDEO)
PDP-503HDE/(E)-a
, P )
B R
INPUT 3 terminal (SCART)
COMPONENT
Y
P P
B R
INPUT 3
MONITOR OUTPUT
VIDEO R–AUDIO–L
INPUT 2
MONITOR OUTPUT
terminals (AUDIO)
INPUT 2 terminal
(SCART)
10
INPUT 4 terminal (VIDEO)
CLEAR button*
INPUT 4 terminals (AUDIO)
INPUT 4 terminal (S-VIDEO)
RS-232C terminal
(used in the factory setup)
RS-232C
(GRAY)
IN OUT
CONTROL
INPUT 1
INPUT 1 terminal SYSTEM CABLE terminal
(GRAY)
(SCART)
CONTROL terminal
8/31/02, 5:08 PM
MEDIA RECEIVER PDP-R03E
SYSTEM CABLE terminal
(WHITE)
SYSTEM
CABLE
(WHITE)
AC INLET
AC INPUT terminal
10