Remote Control; General Control; Speaker Connection; To Turn The Power On - Sharp XL-E12H Operation Manual

System connection (continued)

■ Speaker connection

●
Connect the black wire to the minus
(–) terminal, and the red wire to the
plus (+) terminal.
●
Use speakers with an impedance of
8 ohms or more, as lower
impedance speakers can damage
the unit.
●
Do not mistake the right and the left
channels. The right speaker is the
one on the right side when you face
the unit.
●
Do not let the bare speaker wires touch each other.
●
Do not allow any objects to fall into or to be placed in the
bass reflex ducts.
●
Do not stand or sit on the speakers. You may be injured.

Remote control

■ Battery installation
1 Open the battery cover.
2 Insert the batteries according to the direction indicated
in the battery compartment.
When inserting or removing the batteries, push them
towards the (–) battery terminals.
3 Close the cover.
Caution:
●
Replace all old batteries with new ones at the same
time.
●
Do not mix old and new batteries.

General Control

VOLUME
■ AC power connection
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
RIGHT LEFT
socket. If you plug in the unit first, the unit will enter the
stand-by mode.
Note:
Unplug the AC power lead from the wall socket if the unit
RIGHT
LEFT
will not be in use for a prolonged period of time.
SPEAKERS
Incorrect
●
●
●
●
Notes concerning use:
●
●
●
●

■ To turn the power on

Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-
by mode.
■ Volume auto set-in
●
●

■ Volume control

Turn the volume knob towards VOLUME +/– (on main unit)
or press VOL +/– (on remote control) to increase or
decrease the volume.
E-3
Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
Installing the batteries incorrectly may cause the unit to
malfunction.
Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire or
the like.
Replace the batteries if the operating distance is
reduced or if the operation becomes erratic. Purchase
2 "AAA" size batteries (UM/SUM-4, R03, HP-16 or
similar).
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
Keep the remote control away from moisture, heat,
shock, and vibrations.
If you turn off and on the main unit with volume set to
16 or higher, the volume will start at 16.
If you turn the unit off then on again with the volume
level set to less than 16, it will turn on again at the level
set.