Specifications; Maintenance - Sharp XL-E12H Operation Manual

Troubleshooting chart (continued)
■ Factory reset, clearing all memory
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button repeatedly to select
AUDIO IN function.
3
Press the button on the main unit and then press
and hold down the / button until "RESET" appears.
Caution:
This operation will erase all data stored in memory
including clock, timer settings, tuner preset, and CD
programme.
■ Before transporting the unit
Remove the USB memory device and disc from the unit. Then,
set the unit to the power stand-by mode. Carrying the unit with the
USB memory device or disc left inside can damage the unit.
■ Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on the disc
surface. Follow the guidelines below for maximum enjoyment
from your CD collection and player.
●
Do not write on either side of the disc, particularly the non-
label side from which signals are read. Do not mark this
surface.
●
Keep your discs away from direct sunlight, heat, and
excessive moisture.
●
Always hold the CDs by the edges. Fingerprints, dirt, or water
on the CDs can cause noise or mistracking. If a CD is dirty or
does not play properly, clean it with a soft, dry cloth, wiping
straight out from the centre, along the radius.
NO

Maintenance

■ Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
●
Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet.
●
Do not apply oil to the inside of the unit. It may cause
malfunctions.
YES
Correct
E-14

Specifications

As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification
changes for product improvement without prior notice. The
performance specification figures indicated are nominal
values of production units. There may be some deviations
from these values in individual units.
■ General
Power source AC 220 - 240 V ~ 50/60 Hz
Power Power on: 18 W
consumption Power stand-by: 0.4 W (*)
Dimensions Width:180 mm (7 - 3/32")
Height: 121 mm (4 - 49/64")
Depth: 239 mm (9 - 13/32")
Weight 1.60 kg (3.53 lbs.)
(*)This power consumption value is obtained when the
main unit is in stand-by mode.
■ Amplifier
Output power MPO: 16 W (8 W + 8 W) (10% T.H.D.)
RMS: 10 W (5 W + 5 W) (10% T.H.D.)
Output Speakers: 8 ohms
terminals
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Input terminals AUDIO IN (Analogue input):
500 mV/47 k ohms
■ CD player
Type Single disc multi-play compact disc
player
Signal Non-contact, 3-beam
readout
semiconductor laser pickup
D/A converter Multi bit D/A converter
Frequency 20 - 20,000 Hz
response
Dynamic 90 dB (1 kHz)
range