Installing An Adapter - IBM System x3250 Installation Manual

Attention:
cover is in place and fully closed whenever you install or remove a hard disk drive.
1. Read the safety information that begins on page v and "Installation guidelines"
2. Make sure that the server cover is in place and fully closed.
3. Remove the filler panel from the bay. Store it in a safe place for possible future
4. Open the drive tray handle.
5. Gently push the drive assembly into the bay until the drive stops.
6. Close the drive tray handle.
7. Check the hard disk drive status LED to make sure that the hard disk drive is
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 18.

Installing an adapter

The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
v Because of mechanical interference, when the optional Remote Supervisor
v Locate the documentation that comes with the adapter and follow those
To avoid damage to the hard disk drive connectors, make sure that the
on page 7.
use.
Attention: To maintain proper system cooling, do not operate the server for
more than 10 minutes without either a drive or filler panel installed in each bay.
operating correctly. If the amber hard disk drive status LED for a drive is lit
continuously, that drive is faulty and needs to be replaced. If the green hard disk
drive activity LED is flashing, the drive is being accessed.
Adapter II SlimLine is installed in the server, you cannot install an adapter in
expansion slot 1.
instructions in addition to the instructions in this section. If you have to change
switch settings or jumper settings on the adapter, follow the instructions that
come with the adapter.
Chapter 2. Installing optional devices
13