Shark Navigator UV300 Owner's Manual page 7

Fig. 3
Fig. 4
4 Insert the stretch hose into the
hose connector on the back of
the unit. Make sure that it snaps
in place. (Fig. 3)
5
Store your on-board tools onto
the accessory holder located
on the back of the unit. (Fig. 4)
NOTE: The accessory holder is
removable. In order to remove
or attach the accessory holder,
you must remove the dust cup
first. To remove the accessory
holder, just hold the tab (a),
rotate left and pull out. To
replace, align the pins into
the hinges (b) on the vacuum.
Rotate it fully to secure. (Fig. 5)
Not all accessories are available
on all models.
b
a
Fig. 5
6
When storing your vacuum,
wind the power cord around
the two cord holders and secure
with cord clip. (Fig. 6)
7
There is a Quick Cord Release
on the top cord holder. Simply
turn to the left or right to
release the power cord. To store
the unit, the cord holder should
be in the upright position.
IMPORTANT: For suction to
reach the power nozzle, the
extension wand and stretch
hose must be attached securely
on the vacuum body.
Fig. 6
8
TO CARRY THE VACUUM:
With the unit in the standing
position, lift by the Dust Cup
Handle (carry handle).
CAUTION: When lifting or
carrying, DO NOT press Dust
Cup release button ( ).
www.sharkclean.com
English
5