Initialise With Front Switch; Levelling The Platform (Automatic Or Manual); Automatic Levelling - 3D Printing Systems UP PLUS 2 User Manual

ready.
(Windows version)

5.2 Initialise with front switch

If the printer has just been turned on (in sleep mode), you can initialise the printer by pressing
down the front switch.
To cancel a print job, hold down the front switch for 5 seconds, the platform will then lower and
the printer will enter sleep mode.
6. Levelling the platform (Automatic or
Manual)
There are three different methods to level the platform, the easiest method is automatic.

6.1 Automatic Levelling

1. Ensure your Perfboard is clean and smooth both sides,
as a small piece of plastic could cause the levelling to
be uneven.
2. Plug in the black calibration wire into the back of the
printer.
UP Plus 2 3D Printer User Manual
(Mac version)
v 2013.10.24