Table of Contents
Advertisement
3. Quick Step by Step Setup Guide
two
1. Remove the
and platform in place during shipping.
(keep these for when you move your printer)
2. Attach the "roll holder / feeder guide" onto the left side
of the printer.
3. Open the foil bag that contains the ABS filament.
4. Load the spool of filament onto the roll holder, with the
filament coming out from the back of the roll / printer.
Do not let go of the end of the filament!
UP Plus 2 3D Printer User Manual
packing clips that hold the extruder head
NOTE:
Do not let go of the end of the fila-
ment, otherwise it will unravel itself and tie itself in a
knot, which will then cause a block in the extruder
head and several hours of unwinding the spool manu-
ally to find the knot!
v 2013.10.24
Advertisement
Table of Contents
Need help?
Do you have a question about the UP PLUS 2 and is the answer not in the manual?