A Fault Indicator Light Comes On But The Wash Program Continues As Normal - Miele W 2104 Operating Instructions Manual

A fault indicator light comes on but the wash program
continues as normal.
Problems
The Check drain light
flashes.
The Check inlet light
flashes.
The Excess detergent
check light comes on.
The Main wash
indicator light is
flashing in the
program sequence
display.
The Anti-crease/Finish
indicator light flashes
in the program
sequence display.
A To switch off the fault indicator: switch the washing machine off with the
I-On/0-Off button and turn the program selector to Finish .
Possible cause
The drain outlet is
restricted.
The water inlet is
restricted.
The filter in the
water inlet hose is
dirty
Excessive foam has
built up during
washing.
There is a fault.
The position of the program selector was altered after
the start of the program. Turn the program selector
back to the program previously chosen.
Problem solving guide
Remedy A
Clean the fluff filter and the drain
pump as described in "Problem
solving guide - Opening the door
in the event of a blocked drain
outlet and/or power failure".
Check whether
– the stopcock is opened wide
enough.
– the inlet hose is kinked.
Clean the filter.
Use less detergent next time and
follow the manufacturer's
instructions on dosage given on
the packaging.
Start the program again.
If the fault indicator occurs again,
contact the Service Department.
35