Table of Contents
Advertisement
Check drain
Check inlet
Excess deter-
gent
Main wash
Anti-crease/
Finish
A To switch off the fault indicator: switch the washing machine off with the I-ON/
0-OFF button and turn the programme selector to Finish .
38
The drain outlet is
restricted.
The water inlet is
restricted.
The filter in the
water inlet hose is
dirty
Excessive foam
has built up dur-
ing washing.
There is a fault.
The position of the programme selector was altered after
the start of the programme. Turn the programme selector
back to the programme previously chosen.
Clean the fluff filter and the drain
pump as described in "Problem solv-
ing guide - Opening the door in the
event of a blocked drain outlet and/
or power failure".
Check whether
– the stopcock is opened wide
enough.
– the inlet hose is kinked.
Clean the filter.
Use less detergent next time and fol-
low the manufacturer's instructions
on dosage given on the packaging.
Start the programme again.
If the fault indicator occurs again,
contact the Service Department.
Advertisement
Table of Contents
