Miele W 502 Operating Instructions Manual page 35

Check drain
Check inlet
Excess detergent
Main wash
Anti-crease/Finish The position of the program selector was altered after
A To switch off the fault indicator: switch the washing machine off with the
I-On/0-Off button and turn the program selector to Finish .
The drain outlet is
restricted.
The water inlet is
restricted.
The filter in the
water inlet hose is
dirty
Excessive foam has
built up during
washing.
There is a fault.
the start of the program. Turn the program selector
back to the program previously chosen.
Clean the fluff filter and the drain
pump as described in "Problem
solving guide - Opening the door
in the event of a blocked drain
outlet and/or power failure".
Check whether
– the stopcock is opened wide
enough.
– the inlet hose is kinked.
Clean the filter.
Use less detergent next time and
follow the manufacturer's
instructions on dosage given on
the packaging.
Start the program again.
If the fault indicator occurs again,
contact the Service Department.
A
35