Adjusting The Intended Party S Listening Volume; Switching The Ring Tone; Making A Call By Entering Phone Number; Setting The Private Mode - Pioneer DEH-6150BT Operation Manual

Section
08 Using Bluetooth wireless technology
Adjusting the intended party s
listening volume
To maintain the good speech quality, this unit
can adjust the intended party s listening vo-
lume. If the volume is not enough for intended
party, adjust this function.
1 Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2 Use MULTI-CONTROL to select
END VOLUME.
3 Push MULTI-CONTROL left or right to
select the desired setting.
1 2 3 4 5
# This function can be performed even while
talking on the phone.
# Settings can be stored for each device.

Switching the ring tone

You can select whether to use this unit s ring
tone or not. If this function is set to on, ring
tone from this unit will sound.
1 Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2 Use MULTI-CONTROL to select
RING TONE.
3 Press MULTI-CONTROL to turn ring tone
on.
To turn ring tone off, press MULTI-CONTROL
again.
Making a call by entering
phone number
Important
Be sure to park your vehicle and apply the park-
ing brake when performing this operation.
36
En
1 Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2 Use MULTI-CONTROL to select
NUMBER DIAL.
3 Push MULTI-CONTROL up or down to
select a number.
4 Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
# Up to 32 digits can be entered.
5 When you finish entering the number,
press MULTI-CONTROL.
Call confirmation appears.
6 Press MULTI-CONTROL to make a call.
7 To end the call, press PHONE/
BT MENU.

Setting the private mode

During a conversation, you can switch to pri-
vate mode (talking directly on your cellular
phone).
1 Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2 Use MULTI-CONTROL to select PRIVATE.
3 Press MULTI-CONTROL to turn private
mode on.
To turn private mode off, press
MULTI-CONTROL again.
/