Installation; When Transporting; Before Using Your Refrigerator - Sharp SJ-F72PV Operation Manual

ENG

INSTALLATION

1. This refrigerator is free standing type. Please keep
adequate ventilation space around the refrigerator.
• The figure shows minimum space necessary to
maintain the cooling capability.
• It is possible to use the refrigerator with a less
amount of power consumption by keeping greater
space.
9cm
or more
cm
or more
2. Using the two front Adjustable feet, ensure that the
refrigerator is positioned firmly and level on the floor.
3. When right and left doors are not properly aligned,
adjust using the adjustable feet.
When the left door is raised.
Lower the foot
at right side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4. Remove the 4 screws of the cabinet lower part, and
then set the foot cover (supplied inside the refrigerator
compartment) with removed 4 screws.
Screw
(4 screws)
4
cm
or more
cm
or more
Adjustable foot
When the right door is raised.
Lower the foot
at left side.
Screw
Foot cover
NOTE:
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
• Do not place directly on the ground.
Provide suitable stand.
• To insert the power plug when the door is opened, door
alarm sounds but it is not abnormal. This sound stops
when closing the door.

When transporting

• Using the casters, it is possible to move back and forth.
Casters
• Carry the refrigerator by holding the handles located on
the rear and bottom.

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.