Installation - Sharp SJ-2822M Operation Manual

Installation

1
Keep adequate ventilation space around the
refrigerator.
The picture shows the minimum required space for
installing the refrigerator. The measurement condition
of energy consumption is conducted under a different
space dimension.
60mm
or more
Rear clearance
The space between the rear of the refrigerator and the
wall should be 50mm or more, and less than 75mm. If
the space is wider than 75mm, you may get injured by
touching compressor and its peripheral parts which are
extremely hot during the operation.
Note
• By keeping greater space, the refrigerator may consume
a less amount of power consumption.
• If use the refrigerator in the smaller space dimension
than gured, it may cause temperature rise in the unit,
loud noise and failure.
• Do not push the refrigerator against the wall. The wall
surrounding the refrigerator may get dirty or discolored
because of the air ow caused by heat radiation.
Overall space required in use
90mm
or more
60mm
or more
980mm
2
Use the adjustable foot to place the refrigerator atly
and rmly on the oor.
Adjustable
foot
Note
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
• Do not use shipping materials as a stand.
Place the refrigerator on a hard oor, not directly on the
earthen oor.
In the case of placing the refrigerator on the earthen
oor, use an appropriate base such as a wooden board
under the refrigerator.
Before using your refrigerator
• Clean the inside parts with a cloth soaked in warm
water.
If soapy water is used, wipe it off thoroughly with water.
• Remove packing materials (cushion, blue tapes etc.).
Free standing type
EN-3