Advertisement
Installation
1
Keep adequate ventilation space around the
refrigerator.
• The picture shows
the minimum
required space
for installing the
refrigerator. The
measurement
condition of energy
consumption is
conducted under
a different space
dimension.
• By keeping greater space, the refrigerator may
consume a less amount of power consumption.
• If use the refrigerator in the smaller space
dimension than pictured below, it may cause
temperature rise in the unit, loud noise and failure.
• The space between the rear of the refrigerator
and the wall should be 50mm or more, and less
than 75mm. If the space is wider than 75mm, you
may get injured by touching compressor and its
peripheral parts which are extremely hot during the
operation.
Overall space required in use
1012 mm
2
Use the two front adjustable feet to place the
refrigerator flatly and firmly on the floor.
EN-3
90mm
or more
60mm
60mm
or more
or more
1424 mm
Adjustable foot
3
When right and left doors are not properly aligned,
adjust using the adjustable feet.
When the left door
is raised.
Lower the
foot at right
side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4
Connect the appliance via a correctly installed
socket.
Note
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
• Do not place your refrigerator directly on the ground.
Insert suitable stand such as wooden board under the
refrigerator.
• When you insert the power plug with the door opened,
door alarm sounds but it is normal. This sound stops
after closing the door.
Casters are located on the bottom of the
refrigerator
• The casters allow the refrigerator
to move back and forth.
Before using your refrigerator
• Clean the inside parts with a cloth soaked in warm
water.
• If you use soapy water to clean, wipe it off thoroughly
with water.
Free standing type
When the right door
is raised.
Lower the
foot at left
side.
Casters
Advertisement
