Advertisement
Owner's Guide
Lock Doors
1. Press and release button #1 on the remote transmitter.
2. The park lights will flash and the horn (optional) will honk one time.
3. The remote will beep once to confirm.
4. The doors will lock.
5. The LOCK icon will appear on the LCD display of the remote.
4. The LED's on the antenna will start flashing within five seconds.
Unlock Doors
1. Press and release button #1 on the remote transmitter.
2. The park lights will flash 2 times and the horn (optional) will honk 2 times.
3. The remote will beep twice to confirm.
4. The doors will unlock.
5. The UNLOCK icon will appear on the LCD display of the remote
4. The LED's on the antenna will stop flashing within five seconds.
Trunk Release
1. Press and hold the Trunk Release Button ( Button #2) for three seconds.
2. The doors will unlock and the trunk release will then activate. The Trunk Release will then be
confirmed by 2 park light flashes.
3. The remote will beep once then beep twice to confirm the Trunk Release was activated. The Trunk
Release Icon will appear at the top of the LCD screen for five seconds.
4. For safety reasons, the Trunk Release output will be disabled and will not activate when the ignition
key is in the on position.
Car Finder Mode
1. Press and hold buttons #2 & #3 together for two seconds.
2. The system will flash the park lights and honk the horn(optional) five times.
3. The remote will beep and display the systems current status.
Panic Mode
ACTIVATE PANIC MODE
1. Press and hold Button #1 for three seconds.
2. The park light will begin to flash and the horn will start to honk.
PANIC MODE DISABLE
- Press and release Button #1 to disable Panic Mode and lock the doors.
- Press and release Button #1 to disable Panic Mode and unlock the doors.
Note : Panic Mode will stay activated until disable by the remote transmitter.
Owner's Guide
Remote Start
1. Press and release Button #3 on the remote transmitter.
2. The Park lights will flash and the horn(optional) will honk one time.
3. The remote will beep 3 times and the key icon will begin flashing on the top of the LCD screen.
4. When the vehicle has started, the system will flash the park lights four times then remain "On" while
the vehicle is running. (Normally 15minutes)
5. The Runtime Bar Graph will appear on the LCD screen and begin counting down.
6. The vehicle will continue to run for the programmed runtime. (Normally 15 minutes).
Reservation Mode (Manual Transmissions Only)
TO INSURE SAFE STARTING OF MANUAL TRANSMISSION VEHICLES
1. While the vehicle is running, apply the Park Brake then press & release the Brake Pedal.
2. The park lights will flash to confirm that reservation mode has been activated.
3. Remove the key from ignition (The vehicle will continue to run) exit the vehicle and close the door.
4. The vehicle will shut off when the door is closed. (If the vehicle has a delay dome-light, it may continue
to run until the dome-light turns off)
5. The system is now in Reservation Mode and can be safely Remote Started.
Note: Opening the door after this point will cancel the Reservation Mode*.
*To re-enter the vehicle without cancelling the Reservation Mode. Remote Start the vehicle and unlock
the door's by the remote, (The unlock icon will appear) then open the door. When done, close the door
and press Button #1 on the remote (the system will arm) then press and hold button #3 for three seconds
(The vehicle will turn Off).
Extended Run Time
1. Press and release Button #3 while the vehicle is running under the remote starter.
2. The park lights will flash and the horn (optional) will honk to confirm the runtime has been extended.
The system will reset the runtime (normally 15 minutes).
Note: The Runtime Bar Graph is not updated by the activation of the Extended Runtime.
Remote Stop
1. Press and hold Button #3 for three seconds. The remote starter will shut down.
2. The park lights will flash two times and the horn(optional) will honk two times.
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
Idle Mode
1. Press and release Button #1 while the vehicle is running by the ignition key..
2. The park lights will turn on and the horn(optional) will honk once.
3. The Remote will beep and the Run Time Bar Graph will light up.
4. Turn the ignition key "off" and the vehicle will continue to run.
5. Exit the vehicle and leave it running safely without the keys in the ignition.
Note: Always lock the doors when leaving the vehicle unattended.
Advertisement
