Generator Start-Up Procedure (Auto Mode) - MULTIQUIP MQ POWER DCA-125SSJU Operation And Parts Manual

DCA-125SSJU SERIES — GENERATOR START-UP PROCEDURE (AUTO MODE)
DANGER:
Before connecting this
generator to any
building's electrical
system, a licensed
electrician must install
an isolation (transfer)
switch . Serious injury or death may result without this
transfer switch.
CAUTION:
When connecting the generator to a
isolation (transfer) switch, ALWAYS have
power applied to the generator's internal
battery charger. This will ensure that the
engine will not fail due to a dead battery.
NOTE
WARNING:
When running the generator in the "AUTO"
mode, remember the generator can start up
at any time without warning. NEVER attempt
to perform any maintenance when the
generator is in the auto mode.
28. Perform steps 20 through 22 in the Before Starting
section (page 44) as outlined in the Manual Starting
Procedure .
29. Set the engine speed switch (Figure 69) to the "HIGH"
position.
Figure 69. Engine Speed Switch (High)
DCA-125SSJU SERIES (STANDARD)— PARTS AND OPERATION MANUAL— REV. #4 (06/03/03) — PAGE 45
When the generator is set in the
"AUTO" mode, the generator will
automically start in the event of
comercial power falling below a
prescribed level by means of a
contact closure that is generated
automatically by a transfer switch.
CAUTION:
The Engine Speed Switch must be set
to the "HIGH" position when running in the
Auto-Start mode. Failing to set the switch
in the proper position can result in damage
to your generator when it turns on.
30. Place the Off/Manual/Auto switch (Figure 70) in the
"AUTO" position .
Figure 70. Off/Manual Auto Switch (AUTO)
31. Continue to follow the steps outlined in the " Manual
Start-up" procedure (start at step 11, page 42).