Table of Contents
Advertisement
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: After installation and periodically there-
after, check to ensure that no yellow flame comes in
contact with any log. With the heater set to High,
check to see if flames contact any log. If so, reposi-
tion logs according to the log installation instruc-
tions in this manual. Yellow flames contacting logs
will create soot.
It is very important to install the logs exactly as instructed. Do not
modify logs. Only use logs supplied with heater.
Models CGX3924NT, CGX3924PT, CGX3930NT,
CGX3930PT, CGX3924NR, AND CGX3924PR
1.
Place log #1 (ember bed) onto the base. Position the log over
the shoulder bolts on either side of the front burner. The log
will sit on top of the front burner (see Figure 19).
2.
Place log #2 behind the back burner and onto the three tabs as
shown in Figure 20.
3.
Place log #3 on the left side of the base. It will overlap log #1
and log #2 and will wrap around the front end of the back
burner (see Figure 21).
4.
Place log #4 onto the pins on the right side of log #1 and onto
the "ledge" on the front of log #2 (see Figure 22).
5.
Place log #5 over the knob on log #2 and across the back part
of log #1. It will slant down toward the front (see Figure 22).
Figure 19 - Installing Log #1 [Ember Bed] (Model CGX3930NT
Shown)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
108114-01D
Figure 20 - Installing Log #2 (Model CGX3930NT Shown)
Figure 21 - Installing Log #3 (Model CGX3930NT Shown)
Figure 22 - Installing Logs #4 and #5 (Model CGX3930NT
Shown)
INSTALLATION
15
15
Installing Logs
Advertisement
Table of Contents
