Installing Logs - Desa Comfort Glow CGD3924P Owner's Operation And Installation Manual

INSTALLING
Continued
102991

INSTALLING LOGS

Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this heater may result in
property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log
when installing. It is very important to install these logs exactly as instructed. Do
not modify logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in
the grate base behind the burner (see Figure 17).
2. Place the base of the middle log (#2) in the U-shaped slots of the grate base in front
of the back log. The cutout on the right of the middle log should fit over the burner
(see Figure 18). Make sure the front of the middle log is resting on the tabs of the
grate base and the cutout area is centered over the burner "U" bend.
3. Locate the recesses on the back of the front log (#3). Fit these recesses between
the posts of the grate base (see Figure 19).
4. Locate the notches in the bottom of the crossover log (#4). Place the crossover
log on top of the middle log and front log. Make sure the notches of the cross-
over log lines up with rectangular knobs on top of the middle and front logs
(see Figure 20).
Peg
Hole in
Grate Base
Figure 17 - Installing Back Log (#1)
Front Log (#3)
Post
Figure 19 - Installing Front Log (#3)
WARNING
Back Log (#1)
Tab
Burner
Figure 18 - Installing Middle Log (#2)
Notches
Recess
Rectangular
Post
Knobs
Figure 20 - Installing Crossover Log (#4)
Middle Log (#2)
Cutout
"U" Bend
U-Shaped
Slot
Crossover
Log (#1)
19