Table of Contents
Advertisement
450 SERIES
PAGE 7
SYSTEM WIRING
INSTALL MANUAL
SYSTEM PROGRAMMING - Menu 1
Pin 1- Brown Wire- Siren Output (3amp Maximum)
Connect this wire to the brown or red wire from the alarm siren.
Pin 2- Grey Wire- Trunk Release/Auxiliary Channel 2 (-250ma Output)
This output activates for 0.75 sec when the unlock button is held for 5 seconds.
Pin 3- White/ Blue Wire- Auxiliary Channel 3 (-250ma Output)
This output is activated by pressing the star button on the remote for a min of 3 seconds. The
output is programmable (see Program Menu for options
Pin 4- Orange Wire- Ground When Armed (-250ma Output)
This wire switches to ground when the lock button is pressed. This output can be used for a
external starter disable or to activate such devises as a window roll-up modules.
Pin 5- Black/White Wire- Dome Light Supervision (-250ma Output)
This output activates for 30 seconds when the unlock button is pressed. Connect to a relay to
activate the interior lights or to the headlight circuit for illuminated entry.
Pin 6- White/Green Wire- Second Unlock Output (-250ma Output)
This output will activate when unlock is pressed twice with three seconds.
This wire can be used to install "Driver's Door Priority" or to activate
Pin 7- Blue Wire- Hood Switch input
Negative Input for alarm trigger. This connection is for adding a hood switch. Install the hood
switch then connect the blue wire to it.
Pin 8- Green Wire- Negative Door Pin Input
This connection is for vehicles with negative door pins. Connect to negative trigger output form
the door pin switch. This wire will switch to ground when the door is opened.
Pin 9- Purple Wire- Positive Door Pin Input
This connection is for vehicles with positive door pins. Connect to positive trigger output form
the door pin switch. This wire will switch to 12volts when the door is opened.
Pin 10- Yellow Wire- Switched Ignition Input
12volt switch ignition input. Connect to the vehicles primary ignition wire.
Pin 1- White Wire- Park Light Output (+)
Connect this wire to the vehicles positive parking light wire. If the vehicle has a negative or
multiplex park light switch a relay must be installed to convert the output of the alarm from positive
to negative.
Pin 2- Black Wire- System Ground (-)
Using a self tapping screw, connect this wire to a solid section of the vehicles frame. If required
scrape away the paint to expose bare metal.
Pin 3- Red Wire- 12volt Power Input (+)
Connect this wire to a constant 12volt source such as the main 12volt power for the ignition
switch.
Advertisement
Table of Contents
