GE GDL22KCWSS Owner's Manual And Installation Instructions page 21

9 LEVEL THE REFRIGERATOR
The leveling legs have 3 purposes:
1) Leveling legs adjust so the door closes
easily when opened about halfway.
(Front of the refrigerator should be
1/4" [6 mm] higher than the rear of
the refrigerator).
2) Leveling legs adjust so the refrigerator
is firmly positioned on the floor and
does not wobble.
3) Leveling legs serve as a stabilizing
brake to hold the refrigerator securely
in position during operation and
cleaning.
Turn the leveling legs clockwise to raise the
A
refrigerator, counterclockwise to lower it.
CAUTION:
personal injury or property damage, the
leveling legs must be firmly touching
the floor.
Install the base grille by aligning the
B
prongs on the back of the grille with the
holes in the cabinet. Push forward until
the grille snaps into place.
Freezer
Door (hinge)
models only
Installation Instructions
To avoid possible
SET THE CONTROLS
10
Set the controls to the recommended
setting.
REMOVE PACKAGING
11
START ICEMAKER
(icemaker models)
A) Remove all tape, foam and protective
packing from shelves and drawers.
B) Remove the tie downs from the freezer
baskets.
C) Place half width basket onto drawer
slides. See About the freezer section
for instructions.
Set the icemaker power switch to the
I (on) position. The icemaker will not
begin to operate until it reaches its
operating temperature of 15°F (–9°C)
or below. It will then begin operation
automatically. It will take 2–3 days to
fill the ice bin.
Power
switch
NOTE:
In lower water pressure conditions, the
water valve may turn on up to 3 times
to deliver enough water to the icemaker.
21