Zanussi ZWT71201WA User Manual page 27

The drain hose may be extended to a maxi-
mum of 4 metres. An additional drain hose
and joining piece is available from your local
Service Force Centre. The joining piece must
have an internal diameter of 18 mm.
If your drain hose
looks like this (see
beside) you do not
require the "U"
piece". Just push the
hose firmly in to the
standpipe.
2. Onto a sink outlet spigot.
www.zanussi.com
38 mm (1.5")
standpipe
diamater
30 cm (12")
Min. 60 cm (23.6") Max. 90 cm (35.4")
Loop
If the outlet spigot
has not been used
before, remove any
blanking plug that
may be in place.
If you intend to drain the hose from the ma-
chine into a sink, make sure that the sink is
empty and the plug hole is not blocked. Use
the plastic "U - Piece" supplied.
In the interest of the environment
The appliance should be connected to the
FOUL drainage system, the water will then be
taken to a sewage works for treatment before
being discharged safely into a river.
It is essential that these appliances are not con-
nected to the surface water drainage system as
this water is discharged directly into a river or
stream and may cause pollution.
If you require any further advice please contact
your local water authority.
SHOWER
BATH
WASHING
MACHINE
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
Push the drain hose
onto the spigot and
secure with a clip,
ensure a loop is
formed in the drain
hose (see above) to
prevent waste from
the sink entering the
appliance.
SINK TOILET
BIDET
DISHWASHER
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
TREATED DISCHARGE
RIVER
27