Technical Data - Zanussi ZWT71201WA User Manual

Problem
The machine does not dry or
does not dry properly:
The laundry is full of differ-
ent coloured fluff:
The machine makes an un-
usual noise:
No water is visible in the
drum:
If you are unable to identify or solve the prob-
lem, contact our service centre. Before tele-
phoning, make a note of the model, serial num-
ber and purchase date of your machine: the
Service Centre will require this information.

Technical data

Dimensions
www.zanussi.com
The drying time has not been selected.
• Select the drying time.
The water tap is not turned on.
• Open the water tap.
The drain filter is clogged.
• Clean the drain filter.
The machine is overloaded.
• Reduce the laundry load.
The selected drying time or the drying programme was not suitable for
the laundry.
• Select the suitable drying time/programme for the laundry.
The fabrics washed in the previous cycle released fluff of a different col-
our (refer to "Fluff in the garments" in chapter 'Use - Washing & Drying').
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum repeat the following
procedure twice:
• Thoroughly clean the empty drum, the gasket and the door with a wet
rag.
• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.
Now you can wash other garments.
The machine is fitted with a type of motor which makes an unusual noise
compared with other traditional motors. This new motor ensures a softer
start and more even distribution of the laundry in the drum when spin-
ning, as well as increased stability of the machine.
Machines based on modern technology operate very economically using
very little water without affecting performance.
Width
Height
Depth
Possible cause/Solution
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ... ... ...
60 cm
85 cm
55 cm
23