Zanussi ZWC1301 User Manual page 16

solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the
End pilot light blinks to indicate that the ma-
chine is not working:
• 1 flash: problem with the water supply.
Problem
The machine does not start:
The machine does not fill:
The machine fills then emp-
ties immediately:
The machine does not empty
and/or does not spin:
16
• 2 flashes: problem with the water draining.
• 4 flashes: door open.
Once the problem has been eliminated, press
the button START to restart the programme. If
after all checks, the problem persists, contact
your local Service Centre.
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button Start has not
been pressed.
• Please turn the selector dial and press the button Start again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
• Clean the water inlet hose filter.
The door is not properly closed.
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Installation» chapter.
The drain hose is squashed or kinked.
• Check the drain hose connection.
An option or a programme that ends with the water still in the tub or that
eliminates all the spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Possible cause/Solution
www.zanussi.com