Maintenance And Troubleshooting - Weslo Pursuit 3.2 R Bike User Manual

To select the
speed, time,
distance, or
calories mode
for continuous
display, press
the Display
Mode button
repeatedly. An
indicator will show which mode is selected. Make
sure that there is not an indicator below the word
Scan.
The console can show speed and distance in either
miles or kilometers. The letters "mph" or "km/h" will
appear in the display to show which unit of mea-
surement is selected.
Wichita
To change the unit of measurement, first hold down
EBWL69910
the Display Mode button for a few seconds. The
WLEX61211.0
WLEX61110.0

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries.
To replace the batteries, see assembly step 11 on page
11.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the left
pedal, the resistance knob cover, and the left shield.
newly selected unit of measurement will appear in
the display. Repeat this action to change the unit of
measurement again.
Note: When the batteries are replaced, it may
be necessary to reselect the desired unit of
measurement.
To pause the console, stop pedaling. If the time is
displayed, it will flash. To continue your workout,
simply resume pedaling.
3. When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for a few seconds, the
console will pause. If the pedals do not move for
a few minutes, the console will turn off and the
display will be reset.
Using an adjustable wrench, turn the left pedal clock-
wise and remove it.
Press the tabs on the
sides of the resis-
tance control and pull
the Resistance Knob
(14) upward off the
resistance control.
See the EXPLODED DRAWING on page 19.
Remove the two M3.5 x 19mm Screws (43) and the
three M4 x 19mm Screws (27) from the Left Shield (9).
Then, remove the Left Shield.
15
14
Tab
Tab