Weslo Pursuit 3.2 R Bike User Manual page 16

Locate the Reed Switch (33). Rotate the Pulley (24)
until a Magnet (32) is aligned with the Reed Switch.
Loosen, but do not remove, the indicated M4 x 19mm
Screw (27). Slide the Reed Switch slightly toward or
away from the Magnet.
24
Then, retighten the M4 x 19mm Screw (27). Turn the
Pulley (24) for a moment. Repeat these actions until
the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the left shield, the resistance knob, and the left pedal.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted.
To adjust the drive belt, you must remove the pedals,
the resistance knob cover, and the shields.
Using an adjustable wrench, turn the left pedal
clockwise and remove it. Then, turn the right pedal
counterclockwise and remove it.
Press the tabs on the
sides of the resistance
control and pull the
Resistance Knob (14)
upward off the resis-
tance control.
See the EXPLODED DRAWING on page 19.
Remove the four M3.5 x 19mm Screws (43) and the
six M4 x 19mm Screws (27) from the Left and Right
Shields (9, 10). Then, remove the Left and Right
Shields.
Loosen the two M10 Flange Locknuts (37)—one on
32
33
each side of the Eddy Mechanism (22). Then, tighten
the two M6 Nuts (38) until the Drive Belt (not shown)
is tight. When the Drive Belt is tight, tighten the M10
Flange Locknuts.
27
When the drive belt is correctly adjusted, reattach the
shields, the resistance knob, and the pedals.
16
14
Tab
22
Tab
38
37