Weider Flex 8960 User Manual page 7

5. Slide the nine Weights (35) onto the Weight
Guides (8) with the pin grooves on the side
shown.
Press the Weight Tube Bumper (18) into the
Weight Tube (44). Insert the Weight Tube into the
stack of Weights (35).
Lubricate the indicated holes in the Top Weight
(86) with grease. Slide the Top Weight onto the
Weight Guides (8). Make sure the pin on the
Weight Tube (44) rests in the groove on the
bottom of the Top Weight.
6. Press a 45mm Square Inner Cap (42) into the
Top Frame (9).
Attach the Top Frame (9) to the Top Upright (4)
with an M10 x 65mm Bolt (79), an M10 Split
Washer (43), and an M10 Large Washer (90).
Attach the Top Frame (9) to the Weight Guides
(8) with an M10 x 155mm Bolt (85), two M10
Washers (75), and an M10 Nylon Locknut (76).
Tighten the two M10 Nylon Locknuts (76) used
in step 2.
7. Press two 38mm Round Inner Caps (40) into the
ends of the Crossbar (10).
Attach the two Eyebolts (34) to the Crossbar (10)
with two M8 Washers (59) and two M8 Nylon
Locknuts (65). Do not overtighten the Locknuts;
the Eyebolts must be able to rotate freely.
Attach the Crossbar (10) to the Top Frame (9)
with two M10 x 56mm Bolts (70), two M10 Small
Washers (91), and two M10 Nylon Locknuts (76).
Be sure the Crossbar is attached as shown in
the inset drawing. If the ends point away from
the Top Frame, turn the Crossbar around and
reattach it.
5
8
Lubricate
86
Pin
44
18
35
6
42
75
85
8
7
9
76
65
59
34
40
7
Pin
Groove
79
43
90
9
76
75
4
65
59
10
34
91
70
9
40
10