Using The Camera Search Function - Sanyo VA-SW3050LITE Instruction Manual

■ Using the Camera Search function

This function automatically searches all cameras connected to the network.
• All of the IP addresses for the detected cameras are listed on the [Camera Setting] screen.
• When there are overlapping IP addresses, you can specify the new IP address on the [Camera
Setting] screen.
MEMO:
At the time of factory shipment, the IP address for every camera is set to "192.168.0.2". When you
connect multiple cameras with the factory setting, use the Camera Search function to configure the
unique IP address to the cameras.
1
Click [Search Camera].
The MAC and IP addresses for the cameras
detected are listed in the [Search Camera]
dialog. The addresses are displayed in
ascending order for the MAC address.
2
2
If there are any overlapping IP
addresses, in the [Search Camera]
dialog, select the camera(s) for which
the IP address needs to be changed and
click [Edit].
The [Edit IP Address] dialog appears.
3
1
4
Use the same procedure (steps 2 to 4) until
there are no overlapping addresses
remaining.
5
5
8
Enter new IP address.
4
To change the IP address for a camera, you
must first change the subnet mask and
default gateway values (for the IP address)
on the PC, according to the camera. Note
that you must use the same subnet mask
and the default gateway values as those for
the camera.
Click [OK].
The new IP address is transferred to the
camera(s).
The [Edit IP Address] dialog closes, and the
IP address in the [Search Camera] dialog is
also updated.
Click [OK] in the [Search Camera] dialog.
All the IP addresses displayed in the
[Search Camera] dialog are automatically
reflected in the [Camera Setting] screen.
Note:
If there are any overlapping IP addresses,
the "Duplication Error" message is
displayed. When this error occurs, configure
the IP address again.
English