GE JGBP25GEN Use And Care & Installation Manual page 43

CONVERTING SURFACE BURNERS ON
MODELS EQUIPPED WITH SEALED BURNERS (See
Step 4 if range is equipped with dual burners.)
1. Remove grates, burner caps and burner heads.
2. Remove burner bases by unscrewing the 3
small screws in each base. ~ burner
straight out.
disconnect the wires from the burner
DO NOT
bases unless the cooktop needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
your spuds).
Apply a 3/4" wrench to tie hex
on the gas inlet tube as a back-up when
removing spud to prevent the aluminum
tube horn twisting.
Install orifice spuds accordin to one of the
4.
following diagrams (see
gas or natural gas, depending on which you are
converting to.
B ),
or for LP
Orifice Spuds for Converting to LPGas:
with this Use and Care book. LP or~lce spuds
have a 2-digit number and the Letter "L" on
one side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
Orifice Spuds for Convetiingto Natural Gas:
Natural gas orifice spuds have a 3-digit number
on one side. Each or~lce spud will also have 1, 2
or 3 grooves on one side, denoting the location
on the range where it is to be installed.
43