GE JGBP25GEN Use And Care & Installation Manual page 21

How to Set Oven for Cleaning
Step 1: Turn the OVEN
SET knob to CLEAN.
Push in and turn the
OVEN TEMP knob to ~
CLEAN. Controls will
snap into final position
when the CLEAN
location is reached.
Step 2: Slide the latch —
handle to the right as far
as it will go.
Never force the door
latch handle. Forcing
the handle may damage
the door lock mechanism.
Step 3: Set the automatic oven timer.
Make sure the range
correct time of day.
START and STOP
TIME dials of any
previous timed cooking or cleaning function by: one
at a time, push the DELAY START and STOP TIME
knobs in and turn the knob. Using a light touch,
continue turning the knob until it "pops" out. Both
knobs should now be in the out position.
How to Set a Delayed-Start Cleaning
If you wish to start and stop
cleaning at a later time than shown
on the clock, push in and turn the
DELAY START dial to time you
wish to start. Add the hours needed
for cleaning to this "start" time, then
push in and turn the STOP TIME
dial to this later stop time. The oven
will automatically turn on and off at
the set times.
OVEN S~
6'
OVEN TEMP
Decide on cleaning hours necessary.
Recommended Cleaning Time:
Light to Moderate Soil—2-3 hours (thin spills and
light spatters)
Heavy Soil- hours (heavy, greasy spills and
spatters)
Add these hours to present time of day, then push in
and turn the STOP TIME dial clockwise to this later
stop time.
Oven door gets hot during self-cleaning. DO NOT
TOUCH.
The CLEANING light will glow, indicating the
controls have been set correctly and the clean cycle
has begun. If a delayed start has been selected, the
CLEANING light will not glow until the start time
has been reached and the clean cycle begins. The door
will lock approximately 20 minutes after the clean
cycle has begun.
After a Clean Cycle
After cleaning is comulete, the door will stav locked
Never force the latch handle. The latch slides
easily. Forcing the latch handle may damage
the door lock.
Step 2: Turn the OVEN TEMP knob to OFF.
After a clean cycle, you may notice some white ash in
the oven. Just wipe it up with a damp cloth.
If white spots remain, remove them with a soap-filled
steel wool pad. Be sure to rinse thoroughly with a
vinegar and water mixture. These deposits are usually
a salt residue that can not be removed by the clean
cycle. If the oven is not clean after one cycle, the
cycle may be repeated.
(continued next page)
21