Table of Contents
Advertisement
Wiring Connections
Make sure that you have a good chassis ground. Good ground connections will eliminate most
electrical noise problems. A good chassis ground requires a tight connection to the vehicle's
metal chassis. The area around the ground connection should be clean, bare metal without rust,
paint, plastic, dust, or dirt for a good electrical connection.
To Dash Panel Light
Connect to power antenna or remote for amplifier
Memory +
FUSE
Connect YELLOW to battery or live + 12 Volts of power
Negative Ground -
12 Volt Positive +
Speaker Wiring Notes
Follow the above wiring diagram to install the
head unit with new or existing speakers.
• This unit is designed for use with four (4)
speakers with an impedance between 4 Ohms
to 8 Ohms.
• An impedance load of less than 4 Ohms could
damage the unit.
• Wire Harness Socket
WHITE
ORANGE
YELLOW
BLACK
RED
Left Front
GREEN +
GREEN/WHITE -
Left Rear
BROWN+
BROWN/WHITE -
• Aux. In
• Hole for Mounting Bolt
Right Front
Right Rear
• Never bridge or combine the speaker wire
outputs. When not using four speakers, use elec-
trical tape to tape the ends of the unused speaker
outputs to prevent a short circuit.
• Never ground the negative speaker terminals
to chassis ground.
7
Red = Right
• Antenna Socket
White = Left
• Subwoofer Out
• RCA Line Out
Red = Right
White = Left
GRAY +
GRAY/WHITE -
BLUE +
BLUE/WHITE -
Advertisement
Table of Contents
