Anti-Tip Device - GE JBP80 Use And Care & Installation Manual

Proper care and cleaning are important so your range will give you efficient
and satisfactory service. Follow these directions carefully in caring for it to
help assure safe and proper maintenance.
BE SURE ELECTRIC POWER IS OFF BEFORE CLEANING ANY PART
OF THE RANGE.
A If your range is removed for cleaning, servicing or any reason,
be sure anti-tip device is re-engaged properly when the range
is replaced. Failure to take this precaution could result in tipping of
the range and cause injury.
Control Panel and Knobs
Clean up any spills or spatters with a damp cloth.
Remove heavier soil with warm, soapy water.
Clean the control panel with mild liquid dish detergent
and a soft cloth. Rub the control panel lightly.
CAUTION: Do not use abrasives of any kind on the
control panel. The lettering on models with touch
pads is sensitive to abrasives and pressure.
The control knobs may be removed for easier cleaning.
To remove a knob, pull it straight off the stem. Wash
the knobs in soap and water but do not soak.
Cooktop Surface Light
When changing a cooktop light, do not touch the
metal at the ends of the light.
The cooktop light is easily replaced with a fluorescent
tube of the same wattage. Before changing the light,
pull the plug to the range or disconnect the power at
the main fuse or circuit breaker panel.
To remove:
Lift the light cover by pulling the bottom edge
toward you and then up.
Place fingers on top near each end of the light.
Roll the top of the light gently toward the front of
the range and gently pull the light from the socket,
making sure it does not hit the light cover.
"Sure Grip" Handle
The soft door handle is easy to keep clean. Soil will easily wash off
with soap and water or a non-abrasive all-purpose cleaner. Avoid using
heavy-duty all-purpose cleaners and detergents, as they may contain
chemicals which might harm the sure grip handle.
CARE AND CLEANING
To replace:
Place fingers on the top near each end of the light.
. Press the light into the slots until it snaps into place.
. Move the light cover down and snap into place.