Changing The Virtual Speed Of The Vehicle; Checking The Setting Related With Hardware; Checking The Connections Of Leads And Installation Positions - Pioneer AVIC-HD3II Operation Manual

Modifying the General Settings for Navigation Functions
Changing the virtual speed of
the vehicle
When calculating the expected time of arrival
and the number of hours to the destination,
set the average speed for the motorway or or-
dinary roads using [+] and [-].
1 Touch [Settings] in the navigation
menu, then touch [Regional Settings].
2 Touch [Average Speed].
3 Touch [+] or [-] to set the speed.
p The estimated time of arrival is not necessa-
rily estimated based on this speed value.
Checking the Setting
Related with Hardware
The hardware status, including the driving sta-
tus of a vehicle, positioning status by satellite,
learning status of the 3D sensor, and cable
connection status, can be checked.
Checking the connections of
leads and installation positions
Check that leads are properly connected be-
tween the navigation system and the vehicle.
Please also check whether they are connected
in the correct positions.
1 Touch [Settings] in the navigation
menu, then touch [Hardware].
2 Touch [Connection Status].
The "Connection Status" screen appears.
1 Speed Pulse
The Speed Pulse value detected by the navi-
gation system is shown. [0] is shown while
the vehicle is stationary.
2 GPS Antenna
Indicates the connection status of the GPS
aerial, the reception sensitivity, and from
how many satellites the signal is received. If
the signal is received correctly, [OK] is dis-
played. If reception is poor, [NOK] appears.
In such case, please change the installation
position of the GPS aerial.
3 Phone Connection Status
Indicates the connection status of the Blue-
tooth unit (sold separately) and the signal
strength between the Bluetooth unit and
the mobile phone. If the Bluetooth unit is
connected correctly, [OK] is displayed.
[NOK] appears when the Bluetooth unit is
not connected or incorrectly connected.
4 Installation Position
The installation position of the navigation
system is shown. That indicates whether
the installation position of the navigation
system is correct or not. If installed cor-
rectly, [OK] appears. When the navigation
system is installed at an extreme angle ex-
ceeding the limitation of the installing
angle, [Incorrect angle] will be displayed.
When the angle of the navigation system
has been changed, [Excessive vibration]
will be displayed.
5 Handbrake
When the handbrake is applied, [On] is dis-
played. When the handbrake is released,
[Off] is displayed.
6 Power Voltage
Chapter
10
1
2
3
4
5
6
7
8
79
Engb