Table of Contents
Advertisement
HOW TO FOLD AND MOVE THE INCLINE TRAINER
HOW TO FOLD THE INCLINE TRAINER FOR STORAGE
Before folding the Incline Trainer, adjust the incline to
the lowest position. If this is not done, the Incline Trainer
may be permanently damaged. Remove the key and un-
plug the power cord. CAUTION: You must be able to
safely lift 20 kg (45 lbs.) to raise, lower, or move the
Incline Trainer.
1. Hold the Incline Trainer with your hands in the location
shown by the arrow at the right. CAUTION: To decrease
the possibility of injury, bend your legs and keep your
back straight. As you raise the Incline Trainer, make
sure to lift with your legs rather than your back. Raise
the Incline Trainer about halfway to the vertical position.
2. Move your right hand to the position shown and hold the
Incline Trainer firmly. Using your left hand, pull the latch
knob to the left and hold it. Raise the Incline Trainer until
the latch pin is aligned with the indicated hole in the catch.
Insert the latch pin into the hole. Make sure that the
latch pin is fully inserted into the hole.
To protect the floor or carpet from damage, place a
mat under the Incline Trainer. Keep the Incline Trainer
out of direct sunlight. Do not leave the Incline Trainer
in the storage position in temperatures above 30° C
(85° F).
HOW TO MOVE THE INCLINE TRAINER
Before moving the Incline Trainer, convert the Incline Trainer
to the storage position as described above. Make sure that
the latch pin is fully inserted into the hole in the side of
the Incline Trainer.
1. Hold the handrails as shown and place one foot against a
wheel.
2. Tilt the Incline Trainer back until it rolls freely on the
wheels. Carefully move the Incline Trainer to the desired
location. Never move the Incline Trainer without tipping
it back. To reduce the risk of injury, use extreme cau-
tion while moving the Incline Trainer. Do not attempt
to move the Incline Trainer over an uneven surface.
3. Place one foot against a wheel, and carefully lower the
Incline Trainer until it is resting in the storage position.
Wheels
28
Knob
Hole
Base
Advertisement
Table of Contents
