Generator Shut-Down Procedure - MQ Power DCA-150SSKII Parts And Operation Manual

DCA-150SSKII — GENERATOR SHUT-DOWN PROCEDURE
Engine Shutdown
To shut-down the generator use the following procedure:
1. Place both the MAIN, GFCI and LOAD circuit breakers
to the "OFF position"
2. Turn the Engine Throttle Handle (Figure 63)to the left and
push in to set the speed to 'low'.
Figure 63. Engine Throttle Lever (low)
3. If the generator is equipped with an idle control switch, set
the switch to "OFF" positon. (Figure 64)
Figure 64. Idle Control Switch (OFF)
4. Let the engine cool by running it for 3-5 minutes with no
load applied.
5. Place the Off/Manual/Auto Switch (Figure 65) in the "OFF/
RESET" position.
Figure 65. Off/Manual Auto Switch (OFF)
DCA-150SSKII — PARTS AND OPERATION MANUAL— REV. #1 (05/08/01) — PAGE 51
6. Verify that the "Engine Running" status LED (Figure
66) on the Microprocessor Engine Control Module
(MPEC) display is "OFF" (not lit).
Figure 66. MPEC Engine Running
Status LED (OFF)
7. If the generator is equipped with an ignition switch, (Figure
67) turn the key to the left to the "OFF" positionturn off
the engine.
Figure 67. Off/Manual Auto Switch (OFF)
8. Remove the load from the UNVO terminal strip (Figure 14 -
page 33).
Table of Contents