Table of Contents
Advertisement
A+ Server 1022GG-TF User's Manual
Note: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
Web site at http://www.supermicro.com/products/nfo/storage.cfm.
Installing a Hard Drive to the Hard Drive Tray
1. Remove the two screws securing the dummy drive to the tray.
2. Remove the dummy drive from the tray.
3. Install a new drive into the tray with the printed circuit board side facing
downward so that the mounting holes align with those in the tray.
4. Secure the hard drive by tightening all six screws.
Figure 6-4. Installing a Hard Drive to the Tray
Hard Drive
1
4
Drive Tray
Installing a Hard Drive Tray Into the Chassis
1. Insert the loaded hard drive tray into the drive bay of the chassis
2. Push the drive tray into the drive bay, pushing in the handle of the tray until it
clicks into the locked position.
1
4
6-6
Advertisement
Table of Contents
