Analogue Switch Off; Input Selection And Av Connections; Input Signal Selection - Toshiba Regza C3030 Series Owner's Manual

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 7
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
B
Alternatively press the external source selection button
until the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
B
An S in the display e.g. 2S (EXT 2S), indicates the
input is set for an S-Video signal.
Input selection
At any time by pressing
1
screen showing modes and all stored external
e
equipment. Use and
select.
ATV
PC
HDMI2
HDMI1
B
3C
B
2
B
1
DTV
NOTE: When in digital mode ATV cannot be
selected, in analogue mode DTV cannot be
selected. To switch between DTV and ATV press
the A/D button.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
Input selection and
AV connections
B
a list will appear on
f
to highlight and OK to
ATV
PC
HDMI2
HDMI1
B
3C
B
2
B
1
DTV

INPUT signal selection

This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press
1
AV connection is highlighted, then press OK.
Language
Country
Auto tuning
Manual tuning
Antenna Amplifier
AV connection
Back
MENU
z
With or
2
required input for EXT2.
PC/HDMI1 audio
HDMI1 audio
EXT1 output
EXT2 input
EXT2 output
Woofer
Back
MENU
If the colour is missing try the alternative setting.
33
e
until
SET UP
English
UK
OK
OK
On
OK
Watch TV
EXIT
x
select either AV or S-VIDEO as the
AV connection
PC
Digital
DTV
AV
DTV
Internal
Watch TV
EXIT
1/2