Section 5 − Maintenance And Troubleshooting; Routine Maintenance; High Temperature Help Display - Miller Electric Si 160 Owner's Manual

SECTION 5 − MAINTENANCE AND TROUBLESHOOTING

5-1. Routine Maintenance

n = Check
* To be done by Factory Authorized Service Agent
Every
3
Months
nl Labels
Every
3
Months
n lCables And Cords
Every
6
Months
~:During heavy service, clean monthly.

5-2. High Temperature Help Display

1
OM-250 147 Page 26
.
Maintain more often during severe conditions.
Z = Change ~ = Clean
n l Gas Hoses
Do not remove case when blowing out inside of unit.
Blow out inside. Direct airflow through front and back louvers.
-- -
Disconnect power before maintaining.
= Repair
~ Weld Terminals
2
l = Replace
1 High Temperature Light (LED)
2 Meter Help Display
When unit over heats, High Temperature
light turns on and unit emits an audible
beep. The meter displays three dashes as
shown. Unit shuts down and fans run until
temperature drops within normal operat-
ing range (see Section 3-6).
NOTICE − Wait at least four minutes be-
fore checking to see if temperature is with-
in normal operating range.
956142809_3-6_D